Summary
The Custom Planning Bills screen is where you configure new planning bills you'd like to use for demand disaggregation in Forecast Manager.
It is accessible by clicking Admin > System Configuration > Custom Planning Bills, under Forecast > Planning Bills.
Custom Planning Bills Grid
The grid at the top left of the screen will show currently configured Planning Bills and the associated hierarchy level at which the planning bill was created.
Planning Bill Values/Configure Custom Planning Bill
To configure a new planning bill, begin by hitting the New button in the upper righthand corner of the screen. Enter the Name of your new custom planning bill and the Hierarchy Level at which the bill should exist at. Then in the lower righthand grid, hit the + button to add new values and weights for properties within that hierarchy level. Be sure your weights add up to 100%. When done, hit Save up top.
NOTE: When you add or edit a weight, the value list offers only hierarchy values that are still active. A weight saved on a value that is no longer active shows as <value> (inactive), so you can still change or remove it.
If you would like to clone and modify any existing planning bills, select the planning bill in the upper left grid and hit the Clone button. Modify the Name and the weight values in the lower righthand grid then hit Save.
If you would like to modify the weight values in the Planning Bill Values grid, simply click on the weight, make your edit, and hit enter. Be sure your weights add up to 100%. Then hit Save up top.
If you would like to disable/remove any existing planning bills, select the planning bill in the upper left grid and hit the Delete button
Using a Custom Planning Bill
Saving a custom planning bill does not change any forecast on its own. A custom bill is offered for the hierarchy nodes one level above its Hierarchy Level, and is used only at a node whose Disaggregation Mode is set to Planning Bill with that bill selected. There, its weights replace the fair share weights. You can set this up in two ways in Forecast Manager:
- On the Disaggregation tab, for one node at a time
- In the Edit Child Disaggregation dialog with the Wizard Mode set to Simple, which applies the selected bill to many nodes at once
NOTE: A planning bill applies only at the node where it is selected. Nodes further down the hierarchy do not inherit it.